Cub Cadet RZT L 54-KH RZT L 54 KH Operator's Manual - Page 13
Throttle/Choke Control If so equipped
View all Cub Cadet RZT L 54-KH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Ignition Switch The ignition switch is located on the RH console to the rear of the PTO switch. The ignition switch has three positions as follows: STOP - The engine and electrical system is turned off. RUN - The tractor electrical system is energized. START - The starter motor will turn over the engine. Release the key immediately when the engine starts NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use. Power Take-Off (PTO) Switch The PTO switch is located on the RH console to the left of the hour meter/indicator panel. The PTO switch operates the electric PTO clutch mounted on the bottom of the engine crankshaft. Pull the switch knob upward to engage the PTO clutch, or push the knob downward to disengage the clutch. The PTO switch must be in the "disengaged" position when starting the engine. Transmission Bypass Rods The transmission bypass rods (one for each the RH and LH transmission) are located on the rear of the tractor, just inside each rear wheel. When engaged, the two rods open a bypass within the hydrostatic transmissions, which allows the tractor to be pushed short distances by hand. Refer to the Assembly & Set-Up section for instructions on using the bypass feature. CAUTION: Never tow your tractor. Towing the tractor with the rear wheels on the ground may cause severe damage to the transmissions. Fuel Tank Cap The fuel tank cap is located near the middle of the LH console. Turn the fill cap approximately 1⁄4 turn and pull upward to remove. The fuel cap is tethered to the tractor to prevent its loss. Do not attempt to remove the cap from the tractor. Fill tank to the bottom of the filler neck, allowing some space in the tank for fuel expansion. Do not overfill the tank. Push the cap downward on the fuel tank fill neck and turn approximately 1⁄4 turn clockwise to tighten. Always re-install the fuel cap tightly onto the fuel tank after removing. WARNING! Never fill the fuel tank when the engine is running. If the engine is hot from recently running, allow to cool for several minutes before refueling. Highly flammable gasoline could splash onto the engine and cause a fire. Fuel Level Window The Fuel Level Window is located on the outer left side of the LH console and shows the level of fuel in the gas tank. Throttle/Choke Control (If so equipped) The throttle/choke control is located on the RH console to the left of the hour meter/indicator panel. When set in a given position, a uniform engine speed will be maintained. FAST • Push the throttle/choke control handle forward to increase the engine speed. The tractor is designed to operate with the throttle/choke control in the fast position (full throttle) when the tractor is being driven and the mower deck is engaged. • Pull the throttle/choke control handle rearward to decrease the engine speed. SL OW • When starting the engine, push the control handle fully forward into the "CHOKE" position. • After starting and warming the engine, move the control handle rearward until you feel it move past the choke detent. Cup Holder The cup holder is located toward the middle of the RH console. Storage Tray The storage tray is located at the rear of the RH console. Seat Adjustment Lever The seat adjustment lever is located below the front/left of the seat. The lever allows for adjustment forward or backward of the operator's seat. Refer to the Assembly & Set-Up section for instructions on adjusting the seat position. Section 4 - Controls & Features 13